Low Cost Journal,International Peer Reviewed and Refereed Journals,Fast Paper Publication approved journal IJEDR(ISSN 2321-9939)
apply for ugc care approved journal, UGC Approved Journal, ugc approved journal, ugc approved list of journal, ugc care journal, care journal, UGC-CARE list, New UGC-CARE Reference List, UGC CARE Journals, ugc care list of journal, ugc care list 2020, ugc care approved journal, ugc care list 2020, new ugc approved journal in 2020,
Low cost research journal, Online international research journal, Peer-reviewed, and Refereed Journals, scholarly journals, impact factor 7.37 (Calculate by google scholar and Semantic Scholar | AI-Powered Research Tool)
Design Development of Multipurpose Jig & Fixture of Injection Moulding Die.
Mohsin lalabhai Shaikh,  Dr. Abhang L.B.
this proposed method has to design and fabricate the Multipurpose Jig and Fixture, for that component which has been to reduce the manufacturing cycle time. When the component produced on a small size previously this is to produces the large quantities of requirements. The selective components requires for machining operations such as step milling, angle milling & boring and reaming. The Fixture design has will serve for the economic production for the component. The successful running of all over mass production depends upon the interchange ability to facilitate easy to assembly and reduction of unit cost. There is a necessary of special purpose tools which are used to facilitate the production operation like as machining, assembling, intersecting, etc. to save the calculation time and efforts, four formulas and three analysis models were introduced for calculation of possible UMFs during the assembly process. For the shortest computation time design process. A calibration method reduced from the cascading network relation has been presents to calibrate a symmetric device with an arbitrary test fixture by three measurements techniques. The result analysis indicates the obtained S-parameters of the test fixture have a large error. When the reflection coefficients of the DUT are low, but the calibrated S-parameters of the symmetric DUT is always accurate and even have lower errors than the results obtained by the TRL method
Keywords- Moulding, Fixture, Multi-Purpose, optimization, Effect
Unique Identification Number - IJEDR2003023Page Number(s) - 142-147Pubished in - Volume 8 | Issue 3 | August 2020DOI (Digital Object Identifier) -    Publisher - IJEDR (ISSN - 2321-9939)
Cite this Article
Mohsin lalabhai Shaikh,  Dr. Abhang L.B.,   "Design Development of Multipurpose Jig & Fixture of Injection Moulding Die."
, International Journal of Engineering Development and Research (IJEDR), ISSN:2321-9939, Volume.8, Issue 3, pp.142-147, August 2020, Available at :http://www.ijedr.org/papers/IJEDR2003023.pdf