This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License
|
||||||||
|
Paper Details
Paper Title
Variation in Properties due to Speed in Cold Wire Drawing
Authors
  Prakash Gawali,  DR. S.C.Sharma,  Ashish Khare
Abstract
The speed in cold wire drawing process become very common, because of increase in customer demands and production rate and it is vary essential to the effect of speed on the properties of the drawn wire. In this work the effect of high speed drawing (10m/s &30m/s) on mechanical and technological properties of high carbon steel wire has been investigated. Wire rod 5.50mm from steel grade 0.51% carbon and 0.65% carbon were drawn to 1.35mm in 13 draws and two speeds 10m/sec and 30m/sec. After each draw the following properties were determined; tensile strength (Ts), temperature (T), number of twists (Nt), number of bends (Nb). A large drop in the number of has been observed for final wires because of increased draw speed. However, there is also an advantage as the wire surface is much smoother after drawing at high speed than at low speed. The results were practically and statistically estimated.
Keywords- temperature, tensile strength, speed. Wire drawing
Publication Details
Unique Identification Number - IJEDR1803081Page Number(s) - 481-486Pubished in - Volume 6 | Issue 3 | September 2018DOI (Digital Object Identifier) -    Publisher - IJEDR (ISSN - 2321-9939)
Cite this Article
  Prakash Gawali,  DR. S.C.Sharma,  Ashish Khare,   "Variation in Properties due to Speed in Cold Wire Drawing", International Journal of Engineering Development and Research (IJEDR), ISSN:2321-9939, Volume.6, Issue 3, pp.481-486, September 2018, Available at :http://www.ijedr.org/papers/IJEDR1803081.pdf
Article Preview
|
|
||||||
|